This command behaves like an SNMP access list. To view the controller trap log, choose Monitor and click View All under “Most Recent Traps” on the controller GUI.Ĭreate an SNMP community name by entering this command: config snmp community create nameĭelete an SNMP community name by entering this command: config snmp community delete nameĬonfigure an SNMP community name with read-only privileges by entering this command: config snmp community accessmode ro nameĬonfigure an SNMP community name with read-write privileges by entering this command: config snmp community accessmode rw nameįor IPv4 configuration-Configure an IPv4 address and subnet mask for an SNMP community by entering this command:Ĭonfig snmp community ipaddr ip-address ip-mask name Starting from Release 8.3, SNMP over IPSec, and SNMP Traps over IPSec is supported over IPv6 interfaces. Interface or the service port respectively. The service port, we recommend that you set the SNMP queries to the IP address of theĬontroller has a limitation where, even if the queries are made to the management IPĪddress, SNMP response packets are sent with the source IP address as the dynamic Similarly, if the SNMP management station subnet is the same as that of Recommend that you set the SNMP queries to the IP address of the dynamic interface of If the SNMP management station subnet is the same as that of the dynamic interface, we Interface or service port of the controller. We recommend that you do not have the SNMP management station in the subnet of dynamic Client Traffic Forwarding Configurations.Connecting Mesh Access Points to the Network.
0 kommentar(er)
